FIGURE 1 shows part of a control system used to maintain the water level in a…
FIGURE 1 shows part of a control system used to maintain the water level in a… | savvyessaywriters.org
FIGURE 1 shows part of a control system used to maintain the water level in a
sump between the levels high and low. Two transducers (HIGH and LOW) are
used to monitor the level. The water is pumped out by two pumps, P1 and P2.
The water level in the sump is to be controlled as follows:
? If the level reaches high one pump will start to pump out.
? If the level does not reach low within about 30 seconds, the second pump
will come into action. If the level does reach low before 30 second
pumping should stop.
? If the level does not reach low within about 30 seconds of the second
pump starting, an alarm is given. The alarm is sounded until the level
reaches low. If the level does reach low before 30 seconds the pumping
should stop.
? The pumps will stop when low is detected.
? To give even loading of the pumps they are to be used alternately, e.g. if
on one pump cycle P1 starts first and P2 is the ‘back up’ then on the next
cycle P2 will start first and P1 is the ‘back up’.
Attachments:
Do you need a similar assignment done for you from scratch? We have qualified writers to help you. We assure you an A+ quality paper that is free from plagiarism. Order now for an Amazing Discount!
Use Discount Code “Newclient” for a 15% Discount!
NB: We do not resell papers. Upon ordering, we do an original paper exclusively for you.
The post FIGURE 1 shows part of a control system used to maintain the water level in a… appeared first on Affordable Nursing Writers.